Model-specific reset guide
Canon E488 Ink Absorber Full Reset
The waste ink system in Canon E488 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
What stops Canon E488 from printing
Canon E488 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon E488. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon E488
- Turn the printer off.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon E488
The counter reset normally takes only a few minutes after Canon E488 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon E488 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon E488 is not detected
- Connect Canon E488 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon E488 reset FAQ
How many times should I press Stop/Reset?
For Canon E488, use 5 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon E488
Wic Reset Connect combines a guided reset with support if Canon E488 does not respond as expected.