Canon E480 Printer Ink Absorber Full – How to Reset

Canon E480 Ink Absorber Full Reset

Canon E480 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon E480. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

‘Ink Absorber Full’ / ‘Service Required’ message
Support/service code (varies by series)
Printing blocked after cleaning cycles
Reset required to continue printing

Reset the Ink Absorber Counter

Once the counter is cleared, Canon E480 should exit the locked state and printing should resume normally.

Before You Continue

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

Common Fixes

Try a different USB cable/port if using PC software.
Power-cycle the printer and try again.
Repeat the service mode steps carefully (timing matters).
Close other Canon printer utilities while resetting.
Use the correct Stop/Reset press count for your series.

Frequently Asked Questions

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

How long does it take?

Usually a few minutes once the correct steps are followed.

Guide prepared for Canon E480 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.