Epson TX106 Waste Ink Counter Reset

When the Epson TX106 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX106 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson TX106 Waste Ink Counter

Most Epson TX106 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson TX106 Ink Pad Counter Reset – Quick Steps

1. Βήμα 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX106 via USB (Wi-Fi reset is not supported).
2. Βήμα 2: Run Wic Reset Connect as Administrator and confirm Epson TX106 is detected.
3. Βήμα 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX106.

Most Epson TX106 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

Troubleshooting

• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions