Model-specific reset guide
Canon PRO-10S Ink Absorber Full Reset
The waste ink system in Canon PRO-10S collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
What stops Canon PRO-10S from printing
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon PRO-10S calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon PRO-10S. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon PRO-10S
- Turn the printer off.
- Πατήστε παρατεταμένα Διακοπή/Επαναφορά.
- Ενώ κρατάτε πατημένο το Stop/Reset, πατήστε και κρατήστε πατημένο το Ισχύς.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 φορές.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon PRO-10S
Prepare Canon PRO-10S before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon PRO-10S to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon PRO-10S is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon PRO-10S reset FAQ
Does Canon PRO-10S require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon PRO-10S
Complete the Canon PRO-10S absorber counter reset in a few carefully prepared steps.