Model-specific reset guide
Canon MG3270 Ink Absorber Full Reset
The waste ink system in Canon MG3270 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
Before resetting Canon MG3270
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG3270. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG3270
- Turn the printer off.
- Πατήστε παρατεταμένα Διακοπή/Επαναφορά.
- Ενώ κρατάτε πατημένο το Stop/Reset, πατήστε και κρατήστε πατημένο το Ισχύς.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 φορές.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG3270
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG3270 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG3270 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon MG3270 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon MG3270 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Πόσες φορές πρέπει να πατήσω το Stop/Reset;
For Canon MG3270, use 6 Stop/Reset presses in the sequence shown on this page.
Restore Canon MG3270
Ready to reset Canon MG3270? Verify the power light, USB connection and service-mode state before continuing.