Model-specific reset guide
Canon G4210 Ink Absorber Full Reset
Canon G4210 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
What the Canon G4210 service message means
Canon G4210 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon G4210. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G4210
- Turn the printer off.
- Πατήστε παρατεταμένα Διακοπή/Επαναφορά.
- Ενώ κρατάτε πατημένο το Stop/Reset, πατήστε και κρατήστε πατημένο το Ισχύς.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 φορές.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G4210
Prepare Canon G4210 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G4210 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G4210 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon G4210 reset FAQ
Does Canon G4210 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon G4210
Complete the Canon G4210 absorber counter reset in a few carefully prepared steps.