Epson L4267 Waste Ink Counter Reset

When the Epson L4267 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson L4267 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson L4267 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson L4267 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson L4267 Waste Counter Reset

1. Schritt 1: Connect Epson L4267 to a Windows computer with a stable Internet connection using a USB cable.
2. Schritt 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L4267.
3. Schritt 3: Paste the reset key, click Reset, and after completion power-cycle Epson L4267.

Most Epson L4267 waste counter resets finish in ~1–2 minutes.

System Requirements

• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)

If the Printer Is Not Detected

• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Restart printer and PC, then try again.

FAQ