Epson L3161 Waste Ink Counter Reset
If your Epson L3161 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.
The Epson L3161 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.
What Causes the Epson L3161 Ink Pad Counter Warning?
A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L3161 waste counter reset in minutes.
Typical Signs
- ‘Service Required’ / service life message in driver or utility
- Maintenance/support code (varies by model/driver)
- Printing stops after cleaning cycles
- Warning repeats after restarting the printer
Three Steps to Restore Epson L3161 Printing
- Schritt 1: Connect Epson L3161 to a Windows computer with a stable Internet connection using a USB cable.
- Schritt 2: Start Wic Reset Connect in Administrator mode and wait until Epson L3161 appears in the device list.
- Schritt 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L3161.
Most Epson L3161 waste counter resets finish in ~1–2 minutes.
System Requirements
- Windows 7/8/10/11 PC
- Stable Internet connection during reset
- USB connection required (Wi-Fi reset not supported)
- Valid Wic Reset Connect reset key
If the Printer Is Not Detected
- Try another USB cable (some cables are charge-only).
- Use a direct USB connection (avoid hubs).
- Restart printer and PC, then try again.
- Run the app as Administrator.
- Temporarily disable VPN/proxy if validation fails.
FAQ
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Guide prepared for Epson L3161 – Waste Ink Counter Reset using Wic Reset Connect.