Model-specific reset guide
Canon TS700 Ink Absorber Full Reset
When Canon TS700 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
The waste ink counter inside Canon TS700
The lock is based on accumulated maintenance activity. Resetting Canon TS700 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon TS700. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS700
- Turn the printer off.
- Drücken und halten Sie Anhalten/Zurücksetzen.
- Während Sie Stop/Reset gedrückt halten, drücken und halten Sie Strom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 mal.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS700
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS700 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS700 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon TS700 directly to the computer and try another data-capable USB cable or port.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon TS700 reset FAQ
Wie oft sollte ich Stop/Reset drücken?
For Canon TS700, use 5 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Does Canon TS700 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon TS700
Complete the Canon TS700 absorber counter reset in a few carefully prepared steps.