Model-specific reset guide
Canon TR9060 Ink Absorber Full Reset
Canon TR9060 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
The waste ink counter inside Canon TR9060
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon TR9060 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon TR9060. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TR9060
- Turn the printer off.
- Drücken und halten Sie Anhalten/Zurücksetzen.
- Während Sie Stop/Reset gedrückt halten, drücken und halten Sie Strom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 mal.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TR9060
Prepare Canon TR9060 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TR9060 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TR9060 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon TR9060 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon TR9060 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon TR9060
Complete the Canon TR9060 absorber counter reset in a few carefully prepared steps.