Model-specific reset guide
Canon MB2140 Ink Absorber Full Reset
The waste ink system in Canon MB2140 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
The waste ink counter inside Canon MB2140
Canon MB2140 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon MB2140. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MB2140
- Turn the printer off.
- Drücken und halten Sie Anhalten/Zurücksetzen.
- Während Sie Stop/Reset gedrückt halten, drücken und halten Sie Strom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 mal.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MB2140
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MB2140 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MB2140 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon MB2140 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Wie oft sollte ich Stop/Reset drücken?
For Canon MB2140, use 5 Stop/Reset presses in the sequence shown on this page.
Does Canon MB2140 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MB2140
Ready to reset Canon MB2140? Verify the power light, USB connection and service-mode state before continuing.