Model-specific reset guide
Canon GM4050 Ink Absorber Full Reset
Canon GM4050 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
Understanding the Canon GM4050 ink absorber warning
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon GM4050. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon GM4050
- Turn the printer off.
- Drücken und halten Sie Anhalten/Zurücksetzen.
- Während Sie Stop/Reset gedrückt halten, drücken und halten Sie Strom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 mal.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon GM4050
Prepare Canon GM4050 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon GM4050 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon GM4050 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon GM4050 directly to the computer and try another data-capable USB cable or port.
Canon GM4050 reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon GM4050 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon GM4050
Complete the Canon GM4050 absorber counter reset in a few carefully prepared steps.