Model-specific reset guide
Canon G6010 Ink Absorber Full Reset
When Canon G6010 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
Understanding the Canon G6010 ink absorber warning
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon G6010. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G6010
- Turn the printer off.
- Drücken und halten Sie Anhalten/Zurücksetzen.
- Während Sie Stop/Reset gedrückt halten, drücken und halten Sie Strom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 mal.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G6010
Prepare Canon G6010 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G6010 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G6010 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon G6010 directly to the computer and try another data-capable USB cable or port.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon G6010 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Wie oft sollte ich Stop/Reset drücken?
For Canon G6010, use 5 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon G6010
Complete the Canon G6010 absorber counter reset in a few carefully prepared steps.