Epson ET-2402 Waste Ink Counter Reset

When the Epson ET-2402 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ET-2402 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson ET-2402 Show ‘Service Required’?

Et servicebesøg er ofte unødvendigt. Wic Reset Connect allows a safe Epson ET-2402 waste counter reset in minutes.

Typiske tegn

• ‘Service påkrævet’/meddelelse om levetid i driver eller hjælpeprogram
• Vedligeholdelses-/supportkode (varierer efter model/driver)
• Udskrivning stopper efter rengøringscyklusser
• Advarslen gentages efter genstart af printeren

Three Steps to Restore Epson ET-2402 Printing

1. Trin 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-2402 via USB (Wi-Fi reset is not supported).
2. Trin 2: Åben Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2402.
3. Trin 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2402 to finalize.

Most Epson ET-2402 waste counter resets finish in ~1–2 minutes.

Systemkrav

• Windows 7/8/10/11 PC
• Gyldig Wic-nulstilling Tilslut nulstillingsnøgle
• Stabil internetforbindelse under nulstilling
• USB-forbindelse påkrævet (Wi-Fi-nulstilling understøttes ikke)

Almindelige rettelser

• Luk Epson Status Monitor eller andre printerværktøjer.
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Genstart printeren og pc'en, og prøv igen.
• Kør appen som administrator.
• Prøv et andet USB-kabel (nogle kabler er kun til opladning).