Epson XP-600 Waste Ink Counter Reset

The Epson XP-600 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson XP-600 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson XP-600 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson XP-600 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson XP-600 Waste Ink Counter in 3 Steps

1. Krok 1: Connect Epson XP-600 to a Windows computer with a stable Internet connection using a USB cable.
2. Krok 2: Run Wic Reset Connect as Administrator and confirm Epson XP-600 is detected.
3. Krok 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-600.

Most Epson XP-600 waste counter resets finish in ~1–2 minutes.

What You Need

• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

If the Printer Is Not Detected

• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).

Frequently Asked Questions