特定型号重置指南
Epson XP-600 Reset Waste Ink Counter
When Epson XP-600 reports that an ink pad needs service, restarting the printer alone normally does not clear the lock. A compatible reset procedure is required.
The counter behind the Epson XP-600 warning
Waste ink produced by cleaning cycles is collected inside the printer. Epson XP-600 tracks those cycles electronically and can stop printing when the calculated limit is reached.
Wic Reset Connect 旨在重置兼容的计数器 Epson XP-600. 。必要时仍应检查并维护实体废墨系统。.
Reset the counter in Epson XP-600
按照以下步骤建立稳定的 USB 连接并清除废墨计数器。.
-
安装原始驱动程序
Install the official Epson driver for XP-600 and confirm that Windows can see the printer.
-
通过 USB 直接连接
Connect Epson XP-600 to the computer without Wi-Fi, a hub or an adapter.
-
启动 Wic Reset Connect
Close Epson Status Monitor, run Wic Reset Connect as Administrator and select Epson XP-600.
-
输入密钥并重置
输入已购买的密钥，选择“重置”，并保持打印机连接状态，直到操作完成。.
If Epson XP-600 is not detected
- 将打印机直接连接到计算机。不要使用 Wi-Fi、USB 集线器、扩展坞或打印服务器。.
- 如果未检测到打印机，请尝试其他 USB 端口和已知支持数据传输的 USB 线缆。.
- 清除暂停的打印任务；如果其他程序占用了 USB 连接，请同时重新启动打印机和 Windows。.
- Install the original Epson driver for XP-600; a generic Windows driver may not expose the required communication interface.
Epson XP-600 reset FAQ
重置会清洁或更换墨垫吗？
不会。它会更改存储的计数器值。当实体废墨系统的状况需要时，请对其进行检查、清洁或更换。.
Does Epson XP-600 need service mode?
不需要。Epson 打印机不使用 Canon 服务模式操作顺序。通过 USB 正常连接打印机即可。.
重置需要多长时间？
打印机被正确检测到后，重置本身通常会在约 1–2 分钟内完成。.