Epson WF-2018 Waste Ink Counter Reset

When the Epson WF-2018 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson WF-2018 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson WF-2018 Show ‘Service Required’?

Most Epson WF-2018 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson WF-2018 Printing

1. Krok 1: Prepare a Windows PC + USB cable and connect Epson WF-2018 directly. Keep Internet enabled for validation.
2. Krok 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson WF-2018.
3. Krok 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson WF-2018.

Most Epson WF-2018 waste counter resets finish in ~1–2 minutes.

System Requirements

• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Windows 7/8/10/11 PC