Model-specific reset guide
Canon TS9150 Ink Absorber Full Reset
Canon TS9150 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Why Canon TS9150 reports an absorber error
Cleaning operations send unused ink into absorber pads inside the printer. Canon TS9150 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon TS9150. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS9150
- Turn the printer off.
- Stiskněte a podržte tlačítko Zastavení/resetování.
- Stiskněte a podržte tlačítko Stop/Reset. Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5krát.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS9150
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS9150 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS9150 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Connect Canon TS9150 directly to the computer and try another data-capable USB cable or port.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon TS9150 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon TS9150 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon TS9150
Prepare Canon TS9150, enter service mode and complete the reset with a valid Wic Reset Connect key.