Model-specific reset guide
Canon TR5060 Ink Absorber Full Reset
Canon TR5060 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Understanding the Canon TR5060 ink absorber warning
The lock is based on accumulated maintenance activity. Resetting Canon TR5060 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon TR5060. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TR5060
- Turn the printer off.
- Stiskněte a podržte tlačítko Zastavení/resetování.
- Stiskněte a podržte tlačítko Stop/Reset. Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5krát.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TR5060
Prepare Canon TR5060 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TR5060 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TR5060 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon TR5060 directly to the computer and try another data-capable USB cable or port.
Canon TR5060 reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Kolikrát mám stisknout tlačítko Stop/Reset?
For Canon TR5060, use 5 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon TR5060
Ready to reset Canon TR5060? Verify the power light, USB connection and service-mode state before continuing.