Epson SX130 Waste Ink Counter Reset

The Epson SX130 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson SX130 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson SX130 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson SX130 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson SX130 Waste Ink Counter in 3 Steps

1. Стъпка 1: Connect Epson SX130 to a Windows computer with a stable Internet connection using a USB cable.
2. Стъпка 2: Run Wic Reset Connect as Administrator and confirm Epson SX130 is detected.
3. Стъпка 3: Use the key to reset the counter, wait for completion, then restart Epson SX130 to finalize.

Most Epson SX130 waste counter resets finish in ~1–2 minutes.

System Requirements

• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).