Model-specific reset guide
Canon TR8000 Ink Absorber Full Reset
Canon TR8000 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
What stops Canon TR8000 from printing
The absorber pads collect ink generated during print-head cleaning. Canon TR8000 tracks those maintenance cycles in memory rather than measuring the pads directly.
Wic Reset Connect is designed to reset the compatible counter in Canon TR8000. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TR8000
- Turn the printer off.
- اضغط مع الاستمرار إيقاف/إعادة تعيين.
- أثناء الضغط مع الاستمرار على إيقاف/إعادة الضبط، اضغط مع الاستمرار على الطاقة.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 مرات.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TR8000
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TR8000 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TR8000 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon TR8000 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon TR8000
Complete the Canon TR8000 absorber counter reset in a few carefully prepared steps.