Model-specific reset guide
إعادة الضبط الكامل لممتص الحبر في طابعة Canon MP278
Canon MP278 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Before resetting Canon MP278
The absorber pads collect ink generated during print-head cleaning. Canon MP278 tracks those maintenance cycles in memory rather than measuring the pads directly.
Wic Reset Connect is designed to reset the compatible counter in Canon MP278. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MP278
- Turn the printer off.
- اضغط مع الاستمرار إيقاف/إعادة تعيين.
- أثناء الضغط مع الاستمرار على إيقاف/إعادة الضبط، اضغط مع الاستمرار على الطاقة.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 2 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MP278
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MP278 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MP278 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon MP278 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
كم مرة يجب أن أضغط على زر الإيقاف/إعادة الضبط؟
For Canon MP278, use 2 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon MP278
Use the correct sequence for Canon MP278 and restore printing without an unnecessary service visit.