Model-specific reset guide
إعادة ضبط جهاز امتصاص الحبر MB5480 من كانون MB5480 بالكامل
When Canon MB5480 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
What stops Canon MB5480 from printing
Cleaning operations send unused ink into absorber pads inside the printer. Canon MB5480 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon MB5480. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MB5480
- Turn the printer off.
- اضغط مع الاستمرار إيقاف/إعادة تعيين.
- أثناء الضغط مع الاستمرار على إيقاف/إعادة الضبط، اضغط مع الاستمرار على الطاقة.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 مرات.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MB5480
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MB5480 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MB5480 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon MB5480 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon MB5480 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon MB5480
Follow the verified steps for Canon MB5480, then restart the printer and return to normal operation.