Epson TX650 Waste Ink Counter Reset

When the Epson TX650 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX650 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX650 Stops Printing (Waste Counter Limit)

通常不需要上门服务。. Wic Reset Connect allows a safe Epson TX650 waste counter reset in minutes.

典型标志

• 打印机即使有墨水也拒绝打印
• 爱普生状态监视器显示维护警告
• 闪烁的灯光和受阻的工作
• 设备被锁定，直到执行重置

Three Steps to Restore Epson TX650 Printing

1. 步骤 1： Use a Windows PC (7–11) with Internet access. Connect Epson TX650 via USB (Wi-Fi reset is not supported).
2. 步骤 2： 运行 Wic Reset Connect as Administrator and confirm Epson TX650 is detected.
3. 步骤 3： Use the key to reset the counter, wait for completion, then restart Epson TX650 to finalize.

Most Epson TX650 waste counter resets finish in ~1–2 minutes.

系统要求

• 需要 USB 连接（不支持 Wi-Fi 重置）
• 有效 Wic 复位连接复位键
• Windows 7/8/10/11 电脑
• 重置期间稳定的互联网连接

故障排除

• 试试另一条 USB 电缆（有些电缆只能充电）。.
• 关闭 Epson 状态监视器或其他打印机实用程序。.
• 使用直接 USB 连接（避免使用集线器）。.
• 重新启动打印机和电脑，然后再试一次。.
• 如果验证失败，则暂时禁用 VPN/代理。.

常见问题