特定型号重置指南
Epson SX438W Reset Waste Ink Counter
The service-required message on Epson SX438W often relates to the internal waste ink counter rather than an empty cartridge or paper fault. The steps below help you confirm and resolve that condition.
Why the ink pad counter blocks Epson SX438W
Epson SX438W uses stored counter data to estimate absorber usage. The estimate may reach its limit before the pads appear completely saturated, but physical maintenance should still be considered.
Wic Reset Connect 旨在重置兼容的计数器 Epson SX438W. 。必要时仍应检查并维护实体废墨系统。.
Reset the counter in Epson SX438W
先完成以下连接检查，然后运行重置程序；在此过程中不要打开其他打印机程序。.
-
安装原始驱动程序
Install the official Epson driver for SX438W and confirm that Windows can see the printer.
-
通过 USB 直接连接
Connect Epson SX438W to the computer without Wi-Fi, a hub or an adapter.
-
启动 Wic Reset Connect
Close Epson Status Monitor, run Wic Reset Connect as Administrator and select Epson SX438W.
-
输入密钥并重置
输入已购买的密钥，选择“重置”，并保持打印机连接状态，直到操作完成。.
If Epson SX438W is not detected
- 将打印机直接连接到计算机。不要使用 Wi-Fi、USB 集线器、扩展坞或打印服务器。.
- 以管理员身份运行 Wic Reset Connect，并在整个验证过程中保持互联网连接处于活动状态。.
- 如果未检测到打印机，请尝试其他 USB 端口和已知支持数据传输的 USB 线缆。.
- Install the original Epson driver for SX438W; a generic Windows driver may not expose the required communication interface.
Epson SX438W reset FAQ
重置需要多长时间？
打印机被正确检测到后，重置本身通常会在约 1–2 分钟内完成。.
Can I reset Epson SX438W over Wi-Fi?
不能。Wic Reset Connect 需要通过 USB 直接连接到 Windows 计算机。.
Does Epson SX438W need service mode?
不需要。Epson 打印机不使用 Canon 服务模式操作顺序。通过 USB 正常连接打印机即可。.