Epson L130 Ink Pad Counter Reset Guide

Epson L130 Waste Ink Counter Reset

The Epson L130 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L130 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson L130 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L130 waste counter reset in minutes.

Three Steps to Restore Epson L130 Printing

  1. Step 1: Connect Epson L130 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L130.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson L130 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect 说明

Most Epson L130 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • USB connection required (Wi-Fi reset not supported)
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key

Troubleshooting

  • Restart printer and PC, then try again.
  • Temporarily disable VPN/proxy if validation fails.
  • Use a direct USB connection (avoid hubs).
  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson L130 – Waste Ink Counter Reset using Wic Reset Connect.

购物车