Model-specific reset guide
Canon TS8750 Ink Absorber Full Reset
An absorber warning on Canon TS8750 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
Before resetting Canon TS8750
The lock is based on accumulated maintenance activity. Resetting Canon TS8750 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon TS8750. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS8750
- Turn the printer off.
- 按住 停止/重置.
- 在按住停止/复位的同时，按住 电源.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5次.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS8750
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS8750 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS8750 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon TS8750 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Does Canon TS8750 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
应该按多少次停止/复位键？
For Canon TS8750, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon TS8750
Prepare Canon TS8750, enter service mode and complete the reset with a valid Wic Reset Connect key.