Model-specific reset guide
Canon TS8000 Ink Absorber Full Reset
Canon TS8000 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
What stops Canon TS8000 from printing
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon TS8000. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS8000
- Turn the printer off.
- 按住 停止/重置.
- 在按住停止/复位的同时，按住 电源.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5次.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS8000
Prepare Canon TS8000 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS8000 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS8000 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Connect Canon TS8000 directly to the computer and try another data-capable USB cable or port.
Canon TS8000 reset FAQ
应该按多少次停止/复位键？
For Canon TS8000, use 5 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon TS8000 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon TS8000
Ready to reset Canon TS8000? Verify the power light, USB connection and service-mode state before continuing.