Model-specific reset guide
Canon TR4570S Ink Absorber Full Reset
Canon TR4570S may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Before resetting Canon TR4570S
Cleaning operations send unused ink into absorber pads inside the printer. Canon TR4570S estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon TR4570S. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TR4570S
- Turn the printer off.
- 按住 停止/重置.
- 在按住停止/复位的同时，按住 电源.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5次.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TR4570S
Prepare Canon TR4570S before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TR4570S to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TR4570S is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon TR4570S directly to the computer and try another data-capable USB cable or port.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon TR4570S reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon TR4570S require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
应该按多少次停止/复位键？
For Canon TR4570S, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon TR4570S
Wic Reset Connect combines a guided reset with support if Canon TR4570S does not respond as expected.