Model-specific reset guide
佳能 MG6340 吸墨器完全复位
An absorber warning on Canon MG6340 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
What stops Canon MG6340 from printing
Canon MG6340 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon MG6340. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG6340
- Turn the printer off.
- 按住 停止/重置.
- 在按住停止/复位的同时，按住 电源.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6次.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG6340
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG6340 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG6340 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon MG6340 reset FAQ
应该按多少次停止/复位键？
For Canon MG6340, use 6 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon MG6340
Follow the verified steps for Canon MG6340, then restart the printer and return to normal operation.