Model-specific reset guide
Canon iP4600 Ink Absorber Full Reset
The waste ink system in Canon iP4600 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
The waste ink counter inside Canon iP4600
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon iP4600. The physical waste ink system should still be inspected and maintained when necessary.
Enter service mode on Canon iP4600
The Stop/Reset press count varies across Canon series. Use the complete service-mode guide and select the procedure for this printer instead of guessing.
Reset the counter in Canon iP4600
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the linked guide.
-
Connect directly by USB
Connect Canon iP4600 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon iP4600 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon iP4600 directly to the computer and try another data-capable USB cable or port.
Canon iP4600 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon iP4600 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon iP4600
Ready to reset Canon iP4600? Verify the power light, USB connection and service-mode state before continuing.