Model-specific reset guide
Canon GM2070 Ink Absorber Full Reset
An absorber warning on Canon GM2070 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
What stops Canon GM2070 from printing
The lock is based on accumulated maintenance activity. Resetting Canon GM2070 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon GM2070. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon GM2070
- Turn the printer off.
- 按住 停止/重置.
- 在按住停止/复位的同时，按住 电源.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5次.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon GM2070
The counter reset normally takes only a few minutes after Canon GM2070 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon GM2070 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon GM2070 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon GM2070 reset FAQ
应该按多少次停止/复位键？
For Canon GM2070, use 5 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon GM2070
Wic Reset Connect combines a guided reset with support if Canon GM2070 does not respond as expected.