Model-specific reset guide
Canon G6080 Ink Absorber Full Reset
Canon G6080 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Before resetting Canon G6080
The lock is based on accumulated maintenance activity. Resetting Canon G6080 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon G6080. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G6080
- Turn the printer off.
- 按住 停止/重置.
- 在按住停止/复位的同时，按住 电源.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5次.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G6080
The counter reset normally takes only a few minutes after Canon G6080 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G6080 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G6080 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon G6080 directly to the computer and try another data-capable USB cable or port.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon G6080 reset FAQ
Does Canon G6080 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
应该按多少次停止/复位键？
For Canon G6080, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon G6080
Prepare Canon G6080, enter service mode and complete the reset with a valid Wic Reset Connect key.