Epson L3238 Waste Ink Counter Reset
The Epson L3238 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.
The Epson L3238 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.
Why the Epson L3238 Stops Printing (Waste Counter Limit)
Most Epson L3238 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.
How the Error Appears
- Printer refuses to print even with ink available
- Epson Status Monitor shows maintenance warning
- Blinking lights and blocked jobs
- Device is locked until reset is performed
Three Steps to Restore Epson L3238 Printing
- Step 1: Prepare a Windows PC + USB cable and connect Epson L3238 directly. Keep Internet enabled for validation.
- Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L3238.
- Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson L3238.
Most Epson L3238 waste counter resets finish in ~1–2 minutes.
System Requirements
- Stable Internet connection during reset
- USB connection required (Wi-Fi reset not supported)
- Windows 7/8/10/11 PC
- Valid Wic Reset Connect reset key
Troubleshooting
- Restart printer and PC, then try again.
- Temporarily disable VPN/proxy if validation fails.
- Run the app as Administrator.
- Use a direct USB connection (avoid hubs).
- Try another USB cable (some cables are charge-only).
FAQ
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
Guide prepared for Epson L3238 – Waste Ink Counter Reset using Wic Reset Connect.