Epson XP-413 Waste Ink Counter Reset

If your Epson XP-413 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-413 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson XP-413 Stops Printing (Waste Counter Limit)

Most Epson XP-413 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson XP-413 Printing

1. Крок 1: Use a Windows PC (7–11) with Internet access. Connect Epson XP-413 via USB (Wi-Fi reset is not supported).
2. Крок 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-413.
3. Крок 3: Paste the reset key, click Reset, and after completion power-cycle Epson XP-413.

Most Epson XP-413 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• Stable Internet connection during reset

If the Printer Is Not Detected

• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).

Frequently Asked Questions