Epson WorkForce 630 Waste Ink Counter Reset

When the Epson WorkForce 630 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson WorkForce 630 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson WorkForce 630 Waste Ink Counter

Most Epson WorkForce 630 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Epson WorkForce 630 Ink Pad Counter Reset – Quick Steps

1. Крок 1: Connect Epson WorkForce 630 to a Windows computer with a stable Internet connection using a USB cable.
2. Крок 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson WorkForce 630.
3. Крок 3: Paste the reset key, click Reset, and after completion power-cycle Epson WorkForce 630.

Most Epson WorkForce 630 waste counter resets finish in ~1–2 minutes.

System Requirements

• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset

Common Fixes

• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.

FAQ