Epson TX610FW Waste Ink Counter Reset

The Epson TX610FW is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX610FW uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson TX610FW Waste Ink Counter

Most Epson TX610FW waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson TX610FW Printing

1. Adım 1: Prepare a Windows PC + USB cable and connect Epson TX610FW directly. Keep Internet enabled for validation.
2. Adım 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson TX610FW.
3. Adım 3: Use the key to reset the counter, wait for completion, then restart Epson TX610FW to finalize.

Most Epson TX610FW waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

• Run the app as Administrator.
• Restart printer and PC, then try again.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.