Model-specific reset guide
Canon TS8160 Ink Absorber Full Reset
An absorber warning on Canon TS8160 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
Understanding the Canon TS8160 ink absorber warning
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon TS8160. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS8160
- Turn the printer off.
- Basın ve basılı tutun Durdur/Sıfırla.
- Stop/Reset düğmesini basılı tutarken Güç.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 kez.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS8160
Service mode must be entered correctly before Wic Reset Connect can communicate with the maintenance interface. Resolve other printer errors first.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS8160 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS8160 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon TS8160 reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon TS8160
Ready to reset Canon TS8160? Verify the power light, USB connection and service-mode state before continuing.