Model-specific reset guide
Canon MX347 Ink Absorber Full Reset
Canon MX347 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Before resetting Canon MX347
Cleaning operations send unused ink into absorber pads inside the printer. Canon MX347 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon MX347. The physical waste ink system should still be inspected and maintained when necessary.
Enter service mode on Canon MX347
The Stop/Reset press count varies across Canon series. Use the complete service-mode guide and select the procedure for this printer instead of guessing.
Reset the counter in Canon MX347
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the linked guide.
-
Connect directly by USB
Connect Canon MX347 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MX347 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon MX347 reset FAQ
Stop/Reset düğmesine kaç kez basmalıyım?
The correct count depends on the printer series. Use the linked Canon service-mode guide and do not guess.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Does Canon MX347 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MX347
Complete the Canon MX347 absorber counter reset in a few carefully prepared steps.