Model-specific reset guide
Canon MG5300 Ink Absorber Full Reset
When Canon MG5300 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
What stops Canon MG5300 from printing
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG5300. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG5300
- Turn the printer off.
- Basın ve basılı tutun Durdur/Sıfırla.
- Stop/Reset düğmesini basılı tutarken Güç.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 kez.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG5300
The counter reset normally takes only a few minutes after Canon MG5300 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG5300 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG5300 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon MG5300 directly to the computer and try another data-capable USB cable or port.
Canon MG5300 reset FAQ
Stop/Reset düğmesine kaç kez basmalıyım?
For Canon MG5300, use 6 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon MG5300 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MG5300
Wic Reset Connect combines a guided reset with support if Canon MG5300 does not respond as expected.