Epson XP-214 Waste Ink Counter Reset

When the Epson XP-214 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson XP-214 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson XP-214 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson XP-214 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson XP-214 Waste Ink Counter in 3 Steps

1. Step 1: Connect Epson XP-214 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-214.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson XP-214 to finalize.

Most Epson XP-214 waste counter resets finish in ~1–2 minutes.

System Requirements

• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset

If the Printer Is Not Detected

• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.

FAQ