Fix Epson WorkForce 645 Service Required – Waste Counter Reset

Epson WorkForce 645 Waste Ink Counter Reset

When the Epson WorkForce 645 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson WorkForce 645 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson WorkForce 645 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson WorkForce 645 waste counter reset in minutes.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Reset Epson WorkForce 645 Waste Ink Counter in 3 Steps

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson WorkForce 645 via USB (Wi-Fi reset is not supported).
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson WorkForce 645.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson WorkForce 645.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson WorkForce 645 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson WorkForce 645 – Waste Ink Counter Reset using Wic Reset Connect.

Корпа