Epson WorkForce 633 Waste Ink Counter Reset

The Epson WorkForce 633 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

A waste ink counter in the Epson WorkForce 633 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson WorkForce 633 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson WorkForce 633 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson WorkForce 633 Ink Pad Counter Reset – Quick Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson WorkForce 633 directly. Keep Internet enabled for validation.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson WorkForce 633 appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson WorkForce 633.

Most Epson WorkForce 633 waste counter resets finish in ~1–2 minutes.

What You Need

• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.
• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Run the app as Administrator.