How to Reset Epson PX659 Waste Ink Counter

Epson PX659 Waste Ink Counter Reset

When the Epson PX659 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson PX659 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson PX659 Show ‘Service Required’?

Most Epson PX659 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Three Steps to Restore Epson PX659 Printing

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson PX659 directly. Keep Internet enabled for validation.
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson PX659 appears in the device list.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson PX659 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson PX659 waste counter resets finish in ~1–2 minutes.

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson PX659 – Waste Ink Counter Reset using Wic Reset Connect.

Корпа