How to Reset Epson L4164 Waste Ink Counter

Epson L4164 Waste Ink Counter Reset

If your Epson L4164 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

A waste ink counter in the Epson L4164 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

What Causes the Epson L4164 Ink Pad Counter Warning?

Most Epson L4164 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Three Steps to Restore Epson L4164 Printing

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson L4164 directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L4164.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson L4164 to finalize.

Most Epson L4164 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset

If the Printer Is Not Detected

  • Try another USB cable (some cables are charge-only).
  • Run the app as Administrator.
  • Use a direct USB connection (avoid hubs).
  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.

FAQ

How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson L4164 – Waste Ink Counter Reset using Wic Reset Connect.

Корпа