Epson ET-2814 Ink Pad Counter Reset Guide

Epson ET-2814 Waste Ink Counter Reset

If your Epson ET-2814 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson ET-2814 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson ET-2814 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson ET-2814 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Step-by-Step: Epson ET-2814 Waste Counter Reset

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson ET-2814 directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2814.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-2814.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson ET-2814 waste counter resets finish in ~1–2 minutes.

What You Need

  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key

Troubleshooting

  • Try another USB cable (some cables are charge-only).
  • Use a direct USB connection (avoid hubs).
  • Close Epson Status Monitor or other printer utilities.
  • Run the app as Administrator.
  • Restart printer and PC, then try again.

Frequently Asked Questions

How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson ET-2814 – Waste Ink Counter Reset using Wic Reset Connect.

Корпа