Fix Epson RX610 Service Required – Waste Counter Reset

Epson RX610 Waste Ink Counter Reset

If your Epson RX610 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson RX610 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson RX610 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson RX610 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson RX610 Printing

  1. 1. korak: Connect Epson RX610 to a Windows computer with a stable Internet connection using a USB cable.
  2. 2. korak: Start Wic Reset Connect in Administrator mode and wait until Epson RX610 appears in the device list.
  3. 3. korak: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson RX610.
Buy Reset Key ⬇️ Download Wic Reset Connect Navodila

Most Epson RX610 waste counter resets finish in ~1–2 minutes.

System Requirements

  • USB connection required (Wi-Fi reset not supported)
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson RX610 – Waste Ink Counter Reset using Wic Reset Connect.

Nakupovalna košarica