Model-specific reset guide
Canon MG7700 Ink Absorber Full Reset
The waste ink system in Canon MG7700 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
Before resetting Canon MG7700
Cleaning operations send unused ink into absorber pads inside the printer. Canon MG7700 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon MG7700. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG7700
- Turn the printer off.
- Pritisnite in pridržite Ustavitev/ponastavitev.
- Medtem ko držite Stop/Reset, pritisnite in držite Napajanje.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6-krat.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG7700
The counter reset normally takes only a few minutes after Canon MG7700 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG7700 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG7700 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon MG7700 directly to the computer and try another data-capable USB cable or port.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon MG7700 reset FAQ
Does Canon MG7700 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon MG7700
Wic Reset Connect combines a guided reset with support if Canon MG7700 does not respond as expected.