Epson L132 Waste Ink Counter Reset

The Epson L132 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L132 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson L132 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L132 waste counter reset in minutes.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson L132 Ink Pad Counter Reset – Quick Steps

1. Pasul 1: Connect Epson L132 to a Windows computer with a stable Internet connection using a USB cable.
2. Pasul 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L132.
3. Pasul 3: Paste the reset key, click Reset, and after completion power-cycle Epson L132.

Most Epson L132 waste counter resets finish in ~1–2 minutes.

What You Need

• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset

Troubleshooting

• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).

FAQ