Epson T10 Waste Ink Counter Reset

When the Epson T10 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson T10 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson T10 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson T10 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Step-by-Step: Epson T10 Waste Counter Reset

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson T10 via USB (Wi-Fi reset is not supported).
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson T10.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson T10 to finalize.

Most Epson T10 waste counter resets finish in ~1–2 minutes.

System Requirements

• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

Common Fixes

• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Temporarily disable VPN/proxy if validation fails.

FAQ